Test Equipment & Instrumentation
We know RF design for test equipment and instrumentation.
Test equipment and instrumentation can pose unique design challenges. In order to be used as calibration or measurement “standards”, these applications require significantly higher levels of precision, accuracy and repeatability than the products they will be used to test. NextGen RF has designed a variety of test equipment, test fixtures and calibration standards for clients to meet these demanding requirements.
- Ultra-Wideband, Instrumentation Grade, Peak Power Sensor
- End of Line, RF Over the Air, Bed of Nails Test Fixture and ATS
- High Isolation, Multi-Pin Capacitive Header Test Fixture and Cal Standards
- Semiconductor Wafer Fabrication Equipment
Proven Design Expertise
RF/Wireless
Low noise receivers to high power transmitters. Pre-certified modules or chip down solutions.
Antennas
Custom antenna simulation and design. Three-axis antenna pattern measurements, tuning and
optimization.
Embedded Design
Microprocessors, DSPs, FPGAs, M2M protocol implementation and design.
Digital & Analog
Power supplies, DAC/ADC, USB, Ethernet, UART, SPI, CPRI, high speed memory, voltage
and waveform generation.
Test Fixtures & ATS
EOL and Functional Test Fixtures, fixtures for RF/Wireless, single or multi-up. Automated
Test Systems. Certified LabVIEW programmers.
PCB Design
RF, High Power, and high speed digital expertise. Single sided, double sided, multi-layer.
Altium, Mentor Graphics, OrCAD.